Core Build-Up Material 50ml Cartridge

SkyCore may be used without pins or posts or in conjunction with them
if their use is deemed desirable or necessary.
1.Prepare the abutment tooth (teeth). When using a cartridge for the first time, purge a
small amount of material to insure that both pastes are extruded equally. Discard the
purged material.
2. Dispense the mixture onto the preparation and shape with plastic or metal
instruments or place it into a crown form, which is then placed onto the tooth.
3. The working time is approximately 60 seconds.
4. Removal of crown forms (if used) and final shaping and finishing may start 2 minutes
after SkyCore is placed on the tooth

• Convenient and consistent working and curing times
• Good mechanical strength
• Excellent x-ray opacity
• Needle point tips allow for precise application
• Working time at 23°C (73°F) min. 60 seconds
  Setting time at body temperature 120 seconds Water Extractables (7 days, 37°C) Below 0.02 mg/cm2 pH Neutral Compressive Strength ca 36,000 psi

MADE IN USA